Powrtouch Evolution Manual Release of Rollers

A guide to releasing the Evolution rollers (Auto)

Manual engagement/disengagement of rollers (Evolution Auto)
In the unlikely event of the rollers not retracting off the wheels (Possible Battery Fault). The rollers can be retracted manually from the tyres using a manual removal T-Bar tool.

1) Make sure the Red Isolation Key is removed & handbrake applied

2) Remove the grey cover by gently moving both front and rear to release the clips and pull as shown. (please refer to separate guideline for correct method of removing/fitting the covers)

3) Remove the end bung (shown in the picture below) to locate manual release mechanism

4)  Insert the manual removal tool (T Bar) and turn 14 times anti-clockwise until the unit is fully disengaged.
If in doubt contact a Powrtouch Engineer. Replace end bung & side cover (see separate guideline)

Information from Powrtouch.com
PLEASE NOTE: The Motor Mover manufacturer deals with any problems that may arise, and will send out their own engineer if required, T&C apply.

While we have made every attempt to ensure that the information on these pages has been obtained from reliable sources, Adventure Leisure Vehicles Ltd is not responsible for any errors or omissions, or for the results obtained from the use of this information. All information on this page is provided “as is”, with no guarantee of completeness, accuracy, timeliness or of the results obtained from the use of this information, and without warranty of any kind, express or implied, including, but not limited to warranties of performance and fitness for a particular purpose. In no event will Adventure Leisure Vehicles Ltd including employees be liable to you or anyone else for the decision made or action taken in reliance on the information on these pages or for any consequential, special or similar damages.